Westinghouse SE 6000 Manual de Instalação descarregar pdf (Página 20)

____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.prox.com - MultiProx Controller Installation Manual 6000-900 Rev F 20 of 27

Installation notes for mounting the 5385AGS (side) or B (back) Reader

1. The MultiProx Reader must be located a minimum of 6 inches (15.3cm) away from electrical wiring, conduit,

metal wall studs or metal pipes.

2. The MultiProx Reader must be located a minimum of 2 inches (5.08cm), on all sides, away from any metal

objects. This includes rebar, metal mesh, sheet metal, or metal beams.

3. Mounting the MultiProx Reader in an enclosure is acceptable, provided a minimum of 3 inches (7.62cm)

clearance is maintained on all sides.

4. Insulate all cable connectors with electrical tape or shrink tubing so contact is not made with any metal or

conductive material.

5. The MultiProx Reader should not be mounted within six feet of any monitors (VDTs or CRTs) . The scan

frequencies of most monitors may interfere with the signal received from the access control cards. Motors and

electronic devices generate RF noise that may interfere with the reception of the signal from an access control

card. The effect of RF noise is typically a reduction of read range. The MultiProx is susceptible to RF

interference as are all devices that receive RF signals, such as, radios, television or cellular phones. See also

MultiProx Reader Installation Guide 5385-900-01.

MultiProx Reader Dimensions - Figure 6

7.45"

6.50"

side mount

back mount

1.0"

side mount

back mount

1.0"

0.375"

0.56"

Figure 6

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Sem comentários

Westinghouse SE 6000 Manual de Instalação Página 20