Westinghouse SE 6000 Manual descarregar pdf (Página 8)

Version 5.3 Upgrade Procedure

1-4

SE 6000 Security Management System

8. Remove the 5.3 Update disk and the scratch tape from the system.

This concludes phase 1 of the upgrade procedure. Perform the procedure in Phase 2, Upgrading

UNIX.

PHASE 2 UPGRADING UNIX

You will need the SCO release 5.0.2 tape and the SCO OpenServer Boot Diskette for this phase.

In phase 2, you upgrade the SCO UNIX software from release 3.2/4.2 (or earlier) to Release 5.0.2.

1. Insert the SCO OpenServer Boot Diskette and press any key to reboot the system.

2. At the prompt:

SCO OpenServer(TM) Release 5

Boot

Type :defbootstr adapter=ad(0x134,15,5) and press Enter. The system boots

from the diskette; this takes several minutes.

3. The software displays the SCO UNIX licensing information screen. Press Enter to

continue.

4. The software identifies the installation media. Note that if anything other than SCSI Tape

appears in this field, press F2 to abort. Use the down-arrow key to advance the cursor to

Accept above choices and press Enter.

5. Insert the SCO UNIX installation tape and press Enter.

6. Select the local language of the keyboard and the operating system language and press

Enter to Accept above choices.

7. Using your SCO Licence and Activation document, type the following:

a. Type the licence number, and press Enter.

b. Type the licence code, and press Enter.

c. Type the licence data, and press Enter.

8. Press Enter to Accept above choices. The software tests the tape and then loads the

installation files.

Note

The SCO product displays an information screen based on you systems configuration which

determines whether you can update your current SCO UNIX. The Fresh installation type

displays.

9. Press Enter to continue. The Configuring the basic system screen appears.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Sem comentários

Westinghouse SE 6000 Manual Página 8